Fuel Tank Bulkhead Connector Assembly, 6-Way Bolt-In, Aluminum

BUNG-BCAPX28AL, Bulkhead Wiring Assembly, 6-Conductor, Bolt-In Aluminum

• 6-Conductor Bulkhead Connector, 30 Amps per terminal (max ICS)
• 6061-T6 Black Anodized Aluminum Bolt-in bung
• Viton™/FKM seals, Gas & E85 compatible
• Installs on any flat surface with a 2" hole
• Vapor and liquid proof
• Plug & Play 6-position atmosphere and vapor-side connectors available

The BUNG-BCAPX28AL makes it easy to install up to six individual electrical circuits into your fuel tank. The 6-conductor bulkhead connector can handle up to 30 amps (ICS) which is enough to support the latest high-flow in-tank pumps. The aluminum bung can be bolted onto the top of any fuel tank, fuel cell, surge tank, etc.The bung requires a 2" hole and 6 small holes for 4mm screws. Please see the attached drawings.

A clean flat circular area of 3.5" (90mm) is required for the installation area so that the o-rings can seal properly.

PARTS INCLUDED:

• 1 x 6-conductor APEX 2.8 bulkhead connector
• 1 x Bolt-in bung - Black anodized 6061-T6 aluminum
• 2 x Threaded backing plates - Black anodized 6061-T6 aluminum
• 2 x Viton™/FKM o-rings
• 1 x Retaining ring (c-clip)
• 6 x Crush washers
• 6 x M4 x 25 socket cap screws - stainless steel
• 1 x Silicon grease packet

Mating connector sets are required for the atmosphere and vapor-side connections listed under add-ons below.