FLT1 UHP 340 LPH Fuel Pump Assembly (RXP369)
FPA-003A - LT1 Camaro / Firebird / GTA
High-Performance Fuel Pump Assembly
- Racetronix RXP 340 L/Hr high-performance turbine fuel pump suitable for normally aspirated and forced induction motors
- Plug & Play Teflon in-tank harness - E85 compatible (no adapters)
- High-pressure non-kinking 'Flex' fuel tube with Push-Loc fitting
- Stainless hose clamps
- Custom Racetronix 30 micron high-flow fuel sock
- Assembly adhesive & lubricant included
THE PUMPS
The FPA-033 incorporates our new RXP Turbine-Tech fuel pump which supplies 340 LPH of fuel @ 43.5PSI @ 13.5V*. Racetronix RXP pumps use new turbine technology to reduce pump noise, improve reliability and provide enhanced compatibility with Ethanol enhanced fuels. This pump and harness combination will typically support 600 flywheel horsepower. This HP number may be less with forced induction applications which require richer air/fuel mixtures and higher fuel pressure.
* Our FPWK-033 is required for for a HP pump to meet stated performance specifications because the factory wiring was not designed to handle high-performance pumps which draw more than twice the power of a factory pump. A performance reduction of 15-25% in pump performance can be expected along with reduced reliability when a HP pump is run off of the factory harness.
The LT1 F-body cars have a pump that is inside a plastic fill-bucket. The fill-bucket's inlet and check-valve system in combination with the fuel pump are designed to draw fuel from the bottom of the tank via suction. This keeps the bucket full at all times and the pump fully immersed in fuel regardless of the tank level so that when the tank is low on gas and you are doing some hard cornering or acceleration the pump does not run dry and start aerating (air bubbles) the fuel. This happens as the fuel sloshes from side to side in the tank leaving the center low on fuel. The F-LT1 cars have minimal to no baffling in them. This can cause detonation and possible engine damage. The bucket also allows the car to operate with lower fuel levels in the tank due to its scavenging effect. The bucket can also effect motor cranking time as the priming time is reduced under certain conditions. The return line from the fuel pressure regulator is diverted back into the bucket via a filter sock inside so that the unused fuel also helps keep the bucket full at all times. Keeping the pump constantly immersed in gas within the bucket can extend the pump's life by not allowing it to be exposed to open air. Open air within the tank contains moisture and in time will cause the pump to rust / seize up especially if left to sit for long periods of time without the tank topped-up (i.e. winter storage). The Racetronix pump assembly is modified so that it will seal in the buckets rubber check-valve so that its function is retained. The Racetronix pump assembly is fitted with a factory style fuel tube not a rubber hose. This hose is important as when the fuel module is placed back in the tank it must pivot which can cause the rubber hose to kink. This fuel tube is much more resistant to the solvents in today's gas and it will not crack, split, swell and collapse like a rubber hose. The standard Walbro kit comes with a short length of rated rubber hose.
