4S 36" High-Temp O2 Sensor Extension
$27.50
per EACH O2EXT-4S-36T - Square Black 4-Position 36" HIGH TEMPERATURE
- Fully Plug and Play with the factory harness and sensors
- Mil Spec. Silver / Teflon wire (MIL-W-22759/11, -85°F To 392°F, 4 x 16 AWG wires)
- Black fiberglass woven loom rated to 1200ºF
- Connector locks
- Heat shrunk loom ends (on applicable models)
The high-temperature Teflon
wire and fiberglass loom allow the harness to be placed close to the exhaust
manifolds without the worry of being damaged. The harness's small 1/4"
outer diameter allows it to be routed in tight areas while providing increased
clearance from hot or moving components (i.e. turbo systems). The loom's
black outer jacket provides for a low-key appearance in your engine compartment.
Racetronix oxygen sensor extensions allow for easy relocation of oxygen sensors. This is perfect for the installation of headers which require the oxygen sensor be moved further downstream.
APPLICATIONS:
- C5 LS1 Corvette - Heated Oxygen Sensor (HO2S) Bank1 Sensor 2 (B1S2) Left Rear
- C5 LS1 Corvette - Heated Oxygen Sensor (HO2S) Bank 2 Sensor 2 (B2S2) Right Rear
- LS1 Camaro / Firebird - Heated Oxygen Sensor (HO2S), Left Rear
- LS1 Camaro / Firebird - Heated Oxygen Sensor (HO2S), Right Front
- LS1 Camaro / Firebird - Heated Oxygen Sensor (HO2S), Right Rear
- LS1 Camaro / Firebird - Heated Oxygen Sensor (HO2S), Left Front
CONNECTOR DIAGRAM:
TERMINAL DESIGNATIONS:
| Terminal | Function |
|---|---|
| A | HO2S Low Signal |
| B | HO2S High Signal |
| C | Ground |
| D | Ignition Voltage |
